Chevrolet Cruze 2012 Manual page 1262

BACK TO CHAPTER INDEX
Vehicle Access
Door Lock System Components
The power door lock system consists of the following components:
• Door lock switch - located in the center of the instrument panel
• Body control module (BCM)
• Driver door latch
• Passenger door latch
• Left rear door latch
• Right rear door latch
Door Lock System Controls
The power door lock system can be controlled by any of the following:
• Power door lock switch activation
• Keyless entry lock or unlock command
• A door lock cylinder switch Unlock actuation
• Delayed locking command
• Automatic door lock command
Door Lock and Unlock Operation
When a door lock switch is activated in the lock or unlock position the BCM will receive a ground signal on either the door lock switch lock
or unlock signal circuits.
The BCM, upon receipt of a lock switch lock or unlock signal, will supply battery voltage to the door lock actuator lock or unlock control
circuits. Since the opposite side of the lock actuator is connected to ground through the other lock actuator control circuit, the doors, fuel
filler door and liftgate will then lock or unlock as commanded.
The following three circuits are used to operate the lock:
• Driver door unlock
• Passenger door unlock
• All door lock
The driver door lock actuator is isolated so it can be unlocked by itself using the keyless entry transmitter.
Automatic Door Lock Operation
This feature can be personalized to driver preference.
The BCM will automatically lock the vehicle doors if the following conditions exist:
• All vehicles doors are closed.
• The ignition is in the ON position
• The vehicle is shifted out of Park.
The BCM will then unlock the doors when vehicle is shifted back into Park.
Delayed Locking Operation
With any door open and a door lock switch is activated in the lock position, the BCM will give three audible chimes. When the door is
closed, the BCM will cycle the internal door lock relay to lock the doors after approximately five seconds. This feature can be overridden by
activating the door lock switch a second time and the doors will lock even with a door open.
Lockout Prevention Operation
The BCM will lock all doors and unlock the driver door with a door lock switch lock activation if a vehicle door is open and the ignition key
is fully inserted in the ignition. The lockout prevention feature can be overridden if a lock command is received from the keyless entry
system.
BODY SY S T E M S
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 04
TO MODEL INDEX