Chevrolet Cruze 2012 Manual page 1417

BACK TO CHAPTER INDEX
Power Steering
Special Tools
CH-804 Drive Axle Seal Clamp Pliers
Removal Procedure
1. Remove the steering linkage outer tie rod. Refer to
2. Remove the steering linkage inner tie rod nut (1).
3. Remove the steering gear outer boot clamp (2).
4. Loosen the steering gear inner boot clamp (1). Mark installation position of boot clamp (1) on steering gear.
5. Remove the steering gear boot (1).
Note: After removing the boot, inspect the steering linkage inner tie rod for evidence of corrosion or contamination. If none is
evident, continue with the repair. If corrosion or contamination is evident, replace the inner tie rod.
6. Remove the steering gear inner boot clamp (2).
Installation Procedure
STEERING
Steering Linkage Outer Tie Rod
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Replacement.
TO MODEL INDEX
S e c tion 09