Chevrolet Cruze 2012 Manual page 1421

BACK TO CHAPTER INDEX
Power Steering
1. Install the NEW steering gear oil seal to the steering gear.
2. Ensure the steering gear oil seals are fully seated in the steering gear.
3. Install power steering gear inlet pipe (2) to vehicle.
Caution: Refer to
4. Install 3 bracket nuts (1) and tighten to 9 N·m (80 lb in).
5. Install inlet pipe (3) to power steering pump.
6. Install gasket (2).
7. Install hollow screw (1) and tighten to 21 N·m (16 lb ft).
8. Install inlet hose (3) to clip (2).
9. Install power steering gear inlet hose bolt (1) and tighten to 11 N·m (98 lb in).
10. Clean any excess power steering fluid from the vehicle and remove the drain pans.
11. Install front bumper fascia. Refer to
12. Fill and bleed the power steering system. Refer to
Fastener Caution in the Preface section.
Front Bumper Fascia Replacement
STEERING
Power Steering System Bleeding
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 09
TO MODEL INDEX