Chevrolet Cruze 2012 Manual page 1579

BACK TO MAIN INDEX
Special Tools
• CH 41013 Rotor Resurfacing Kit
• CH 42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to
Removal Procedure
Warning: Refer to
1. Remove rear brake caliper bracket. Refer to
2. Matchmark the position of the brake rotor to the wheel studs.
3. Remove the rear brake rotor bolt (2).
4. Remove rear brake rotor (1) from the wheel hub.
Installation Procedure
1. Using the CH 42450-A kit , thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange.
2. Using the CH 41013 kit , thoroughly clean any rust or corrosion from the mating surface and mounting surface of the brake rotor.
3. Inspect the mating surfaces of the hub/axle flange and the rotor to ensure that there are no foreign particles or debris remaining.
4. Install the brake rotor (1) to the hub/axle flange. Use the matchmark made prior to removal for proper orientation to the flange.
Caution: Refer to
5. Install rear brake rotor bolt (2) and tighten to 7 N·m (62 lb in).
6. If the brake rotor was removed and installed as part of a brake system repair, measure the assembled LRO of the brake rotor to
ensure optimum performance of the disc brakes. Refer to
7. If the brake rotor assembled LRO measurement exceeds the specification, bring the LRO to within specifications. Refer to
Assembled Lateral Runout Correction.
Special Tools.
Brake Dust Warning in the Preface section.
Rear Brake Caliper Bracket Replacement
Fastener Caution in the Preface section.
ADDITIONAL LINKS
Brake Rotor Assembled Lateral Runout Measurement.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 00
Brake Rotor
TO MODEL INDEX