Chevrolet Cruze 2012 Manual page 1393

BACK TO CHAPTER INDEX
Supplemental Inflatable Restraints
Warning: A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a
deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause
personal injury.
5. Disconnect the steering wheel module yellow connector (1) from vehicle harness yellow connector (3).
Note: If the vehicle is equipped with dual stage air bags the steering wheel module and instrument panel module will each have
4 wires. Refer to
6. Cut the yellow harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
7. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
8. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gauge) or thicker multi-strand wire. Use these wires to fabricate the
driver deployment harness.
9. Strip 13 mm (0.5 in) of insulation from both ends of the wires.
10. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected
to a power source until you are ready to deploy the inflator module.
Component Connector End Views
RESTRAINTS
for determining high and low circuits.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 08
TO MODEL INDEX