Chevrolet Cruze 2012 Manual page 1466

BACK TO CHAPTER INDEX
Front Suspension
Special Tools
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to
Removal Procedure
1. Raise and support the vehicle. Refer to
2. Remove the tire and wheel. Refer to
Note: DO NOT re-use the lower control arm bolts and nuts. Discard and use NEW only.
3. Remove wheel speed sensor wiring harness from control arm and steering knuckle.
4. Remove and DISCARD the lower ball joint to knuckle nut and bolt (1).
5. Separate the lower control arm from the knuckle.
6. Remove and DISCARD the front lower control arm nut and bolt (1).
7. Remove and DISCARD the rear lower control arm bushing nuts and bolts (1).
SUSPENSION
Special Tools.
Lifting and Jacking the
Tire and Wheel Removal and
Vehicle.
Installation.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 10
TO MODEL INDEX