Chevrolet Cruze 2012 Manual page 1521

BACK TO CHAPTER INDEX
Wheel Alignment
Steering and vibration complaints are not always the result of improper alignment. One possible cause is wheel and tire imbalance.
Another possibility is tire lead due to worn or improperly manufactured tires. Lead/pull is defined as follows: At a constant highway speed
on a typical straight road, lead/pull is the amount of effort required at the steering wheel to maintain the vehicle's straight path. Lead is
the vehicle deviation from a straight path on a level road without pressure on the steering wheel.
Before performing any adjustment affecting wheel alignment, perform the following inspections and adjustments in order to ensure correct
alignment readings:
• Inspect the tires for the proper inflation and irregular tire wear.
• Inspect the runout of the wheels and the tires.
• Inspect the wheel bearings for backlash and excessive play. Refer to
• Inspect the ball joints for looseness or wear.
• Inspect the tie rod ends for looseness or wear.
• Inspect the control arms and stabilizer shaft for looseness or wear.
• Inspect the steering gear for looseness at the frame.
• Inspect the struts/shock absorbers for wear, leaks, and any noticeable noises. Refer to
- On Vehicle.
• Inspect the steering wheel for excessive drag or poor return due to stiff or rusted linkage or suspension components.
• Inspect the fuel level. The fuel tank should be full or the vehicle should have a compensating load added.
Give consideration to excess loads, such as tool boxes, sample cases, etc. If normally carried in the vehicle, these items should remain in
the vehicle during alignment adjustments. Give consideration also to the condition of the equipment being used for the alignment. Follow
the equipment manufacturer's instructions.
Satisfactory vehicle operation may occur over a wide range of alignment settings. However, if the setting exceeds the service allowable
specifications, correct the alignment to the service preferred specifications. Refer to
Perform the following steps in order to measure the front and rear alignment angles:
1. Install the alignment equipment according to the manufacturer's instructions.
2. Jounce the front and the rear bumpers 3 times prior to checking the wheel alignment.
3. Measure the alignment angles and record the readings.
Note:
• Record the "Before" and "After" alignment measurements.
• When performing adjustments to vehicles requiring a 4-wheel alignment, set the rear wheel alignment angles first in order to
obtain proper front alignment angles.
4. Adjust alignment angles to vehicle specification, if necessary. Refer to
SUSPENSION
Suspension Strut and Shock Absorber Testing - On Vehicle
Wheel Alignment Specifications
Wheel Alignment
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Suspension Strut and Shock Absorber Testing
Specifications.
TO MODEL INDEX
S e c tion 10