Chevrolet Cruze 2012 Manual page 1418

BACK TO CHAPTER INDEX
Power Steering
1. Install a new clamp (2) loosely on the inner part of the steering gear boot.
2. Apply grease from the service kit to the indicated locations.
Note: The steering gear boot must seat in the appropriate groove on the steering gear.
3. Install the steering gear boot (1) over the steering linkage inner tie rod and onto the steering gear.
4. Adjust boot clamp (1) to marking on steering gear to keep correct installation position.
5. Using CH-804 pliers crimp the inner steering gear boot clamp (1).
6. Install the steering gear outer boot clamp (2).
7. Install the steering linkage inner tie rod nut (1).
8. Install the steering linkage outer tie rod. Refer to
2 of 2
STEERING
Steering Linkage Outer Tie Rod
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Replacement.
TO MODEL INDEX
S e c tion 09