Chevrolet Cruze 2012 Manual page 1567

BACK TO MAIN INDEX
Special Tools
CH 49800 Installer Power Steering Pump Belt
For equivalent regional tools, refer to
Removal Procedure
Caution: Do not use belt dressing on the drive belt. Belt dressing causes the breakdown of the composition of the drive belt. Failure
to follow this recommendation will damage the drive belt.
1. Open the hood.
2. Cut the power steering pump belt (2) with a appropriate cutting tool at position (1).
3. Remove the power steering pump belt (2)
Installation Procedure
1. Relieve the tension of the drive belt (1). Refer to
2. Install CH-49800 installer (3) on the power steering pump pulley.
3. Install NEW power steering belt (2) aligning pulley water pump.
4. Rotate the power steering pump pulley clockwise using hex wrench on the shaft power steering pump pulley.
5. Remove the CH-49800 installer (3).
6. Check the belt is installed clearly.
7. Install the drive belt. Refer to
8. Close the hood.
ADDITIONAL LINKS
Special Tools.
Drive Belt
Drive Belt Installation
Replacement.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 00
TO MODEL INDEX