Chevrolet Cruze 2012 Manual page 1486

BACK TO CHAPTER INDEX
Rear Suspension
8. Remove the wheel bearing/hub assembly (1) from the rear axle assembly and brake backing plate.
Installation Procedure
1. Install the wheel bearing/hub assembly (1) to the brake backing plate and the rear axle assembly.
Caution: Refer to
Note: Tighten the bolts evenly, in a cross-pattern.
2. Install the wheel bearing/hub mounting bolts (1) and tighten to 50 N·m (37 lb ft) + 40° , using the EN 45059 kit.
Tighten the bolts evenly, in a cross-pattern.
Fastener Caution in the Preface section.
SUSPENSION
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 10
TO MODEL INDEX