Chevrolet Cruze 2012 Manual page 1478

BACK TO CHAPTER INDEX
Front Suspension
The front suspension has 2 primary purposes:
• Isolate the driver from irregularities in the road surface.
• Define the ride and handling characteristics of the vehicle.
The front suspension absorbs the impact of the tires travelling over irregular road surfaces and dissipates this energy throughout the
suspension system. This process isolates the vehicle occupants from the road surface. The rate at which the suspension dissipates the
energy and the amount of energy that is absorbed is how the suspension defines the vehicles ride characteristics. Ride characteristics are
designed into the suspension system and are not adjustable. The ride characteristics are mentioned in this description in order to aid in the
understanding of the functions of the suspension system. The suspension system must allow for the vertical movement of the tire and
wheel assembly as the vehicle travels over irregular road surfaces while maintaining the tire's horizontal relationship to the road.
This requires that the steering knuckle be suspended between a lower control arm and a strut assembly. The lower control arm attaches
from the steering knuckle at the outermost point of the control arm. The attachment is through a ball and socket type joint. The innermost
end of the control arm attached at 2 points to the vehicle frame through semi-rigid bushings. The upper portion of the steering knuckle is
attached to a strut assembly. The strut assembly then connects to the vehicle body by way of an upper bearing. The steering knuckle is
allowed to travel up and down independent of the vehicle body structure and frame.
This up and down motion of the steering knuckle as the vehicle travels over bumps is absorbed predominantly by the coil spring. This
spring is retained under tension over the strut assembly. A strut is used in conjunction with this system in order to dampen out the
oscillations of the coil spring. A strut is a basic hydraulic cylinder. The strut is filled with oil and has a moveable shaft that connects to a
piston inside the strut. Valves inside the shock absorber offer resistance to oil flow and consequently inhibit rapid movement of the piston
and shaft. Each end of the shock absorber is connected in such a fashion to utilize this recoil action of a spring alone. Each end of the strut
is designed as the connection point of the suspension system to the vehicle and acts as the coil spring seat. This allows the strut to utilize
the dampening action to reduce the recoil of a spring alone. The lower control arm is allowed to pivot at the vehicle frame in a vertical
fashion. The ball joint allows the steering knuckle to maintain the perpendicular relationship to the road surface.
Front suspensions systems utilize a stabilizer shaft. The stabilizer bar connects between the left and right lower control arm assemblies
through the stabilizer link and stabilizer shaft insulators. This bar controls the amount of independent movement of the suspension when
the vehicle turns. Limiting the independent movement defines the vehicles handling characteristics on turns.
SUSPENSION
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 10
TO MODEL INDEX