Chevrolet Cruze 2012 Manual page 1484

BACK TO CHAPTER INDEX
Rear Suspension
Installation Procedure
1. Position the rear brake shield (2) and wheel bearing/hub assembly (1) in the rear axle.
Caution: Refer to
2. Install the NEW wheel bearing/hub mounting bolts (1) and tighten to 50 N·m (37 lb in) + 40° using the EN 45059 kit .
3. Install the wheel speed sensor (2).
4. Install the wheel speed sensor screw (1) and tighten to 6 N·m (54 lb in). Tighten the bolts evenly, in a cross-pattern.
5. Install the brake rotor, and install the brake caliper and bracket as an assembly. Refer to
6. Install the tire and wheel assembly. Refer to
7. Remove the support and lower the vehicle.
Fastener Caution in the Preface section.
Tire and Wheel Removal and
SUSPENSION
Installation.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
Rear Brake Rotor Replacement.
TO MODEL INDEX
S e c tion 10