Chevrolet Cruze 2012 Manual page 1468

BACK TO CHAPTER INDEX
Front Suspension
Caution: Refer to
4. Support the lower control arm with a hydraulic jack and lift the control arm into the neutral position.
5. Tighten the front lower control arm bolt (1) to 70 N·m (52 lb ft) +75-90 degrees , using EN-45059 kit .
6. Tighten the rear bushing to frame bolts to 55 N·m (41 lb ft) +45-60 degrees , using EN-45059 kit .
7. Install the NEW ball joint to knuckle bolt and nut and tighten to 30 N·m (22 lb ft) +60-75 degrees , using EN-45059 kit .
Lower the vehicle to the ground in order to tighten the control arm fasteners correctly.
8. Remove the jack stand.
9. Install the tire and wheel. Refer to
10. Lower the vehicle.
Fastener Caution in the Preface section.
Tire and Wheel Removal and
SUSPENSION
Installation.
CHEVROLET CRUZE BODY REPAIR MANUAL 2010
S e c tion 10
TO MODEL INDEX