Tool List - JLG 400S Service And Maintenance Manual

Tool List

The following specialized tools are used to assemble this unit.
Tool diagrams in this manual are intended for the customer
who may wish to have a tool made. All tools are one piece and
must be made from mild steel. All dimensions are in inches.
NOTE: Tools may be carburized and hardened to improve tool life.
If this is done, tools must be ground on all surfaces labeled
with a "G" on the tool diagram.
1. T-118126 SEAL PRESSING TOOL FOR SEAL (1B).
2. T-138903 ASSEMBLY PRESSING TOOL FOR CUP (1C).
3121671
SECTION 3 - CHASSIS & TURNTABLE
3. T-140433 ASSEMBLY PRESSING TOOL FOR CUP
4. T-109691 ASSEMBLY PRESSING TOOL FOR CONE (1F).
* These tools are for specific seals, cups or cones. There is a
specific tool for each cup and cone.
(1E).
3-25