Diagnostics & Troubleshooting - JLG 400S Service And Maintenance Manual

SOFT TOUCH ONLY
If Soft Touch only is selected in machine setup (refer to Table
6-2), machine will treat the Soft Touch/SkyGuard override
switch as if it is a Soft Touch switch.
SKYGUARD NOT SELECTED IN MACHINE SETUP
If the SkyGuard system is installed on the machine, but no
option is selected in the machine setup (refer to Table 6-2),
SkyGuard sensor status will be ignored. No function cutout or
reversal will be implemented.
Diagnostics & Troubleshooting
If SkyGuard does not function when the sensor is engaged,
first verify the configuration under the
MACHINE SETUP: SKYGUARD OPTION menu using the hand-
held Analyzer. Ensure the selected configuration matches the
actual system installed on the machine. If not, select the cor-
rect configuration, then verify operation.
Additionally, use the handheld analyzer to navigate to the
DIAGNOSTICS: FEATURES  SKYGUARD INPUTS menu to
determine additional SkyGuard fault information.
Drive
Forward
R * / C * *
R = Indicates Reversal is Activated
C = Indicates Cutout is Activated
* DOS Enabled
* * DOS Not Enabled, machine is driving straight without steering, and any other hydraulic function is active
3121671
Table 4-1. SkyGuard Function Table
Drive Boom
Steer Swing
Reverse Lift Up
R C R R
Engage the SkyGuard sensor and observe the Analyzer to
determine if the switch/relay closes.
If the status of the switch/relay remains OPEN while the Sky-
Guard sensor is actively engaged, it is possible the sensor has
failed and should be replaced immediately.
If the status of the switch/relay remains CLOSED while the Sky-
Guard sensor is actively engaged, a power or ground wire may
not be making good contact or may be loose or broken. Addi-
tionally, there is a low probability that both relays may have
failed.
If the switch/relay status is in disagreement, then one may
have failed or is not installed correctly. In this case, the
machine will be inoperable.
FAULT CODES
Refer to Table 6-11 for more fault code information
• 0039 - SkyGuard switch activation fault
• 2563 - switch disagreement fault
Boom
Boom Boom
Lift Jib Lift
Tele Out Tele In
Down
R R C C
SECTION 4 - BOOM & PLATFORM
Basket Basket
Level Rotate
C C
4-53