JLG 400S Service And Maintenance Manual page 220

SECTION 3 - CHASSIS & TURNTABLE
Deutz Blink
SPN FMI
Code Code
110 3 96 225
110 4 97 225
111 1 101 235
157 3 877 147
157 4 878 147
164 2 1381 839
168 0 1180 318
168 1 1181 318
168 2 47 318
168 3 45 318
168 4 46 318
3-162
Table 3-16. Deutz Engine Fault Codes
Description
Coolant temperature sensor: the voltage of
the sensor measured by ECU is out of the
tar- get range.
Coolant temperature sensor: the voltage of
the sensor measured by ECU is out of the
tar- get range.
Coolant level: the coolant level calculated
by
ECU is underneath the allowed minimum.
Rail pressure sensor: the voltage of sensor
measured by ECU is out of the target range.
Rail pressure sensor: the voltage of sensor
measured by ECU is out of the target range.
Rail pressure safety function is not
executed correctly
Battery voltage: the voltage measured by
ECU is out of the target range
Battery voltage: the voltage measured by
ECU is out of the target range
Battery voltage: the voltage measured by
ECU is out of the target range, system
reaction is initiated
Battery voltage: the voltage measured by
ECU is out of the target range, system
reaction is initiated
Battery voltage: the voltage measured by
ECU is out of the target range, system
reaction is initiated
Possible Cause
Short cut to battery or open load.
Voltage Surveillance has found shortcut to
Ground at Coolant Temperature Sensor.
Coolant level too low, leakage in cooling
system, sensor defective, wiring damaged.
Short cut to battery.
Damaged rail pressure sensor.
Check cabling, check rail pressure sensor and if
necessary replace it,
check connection cable and if necessary repair
or replace it.
Rail pressure is still above threshold.
Battery voltage over limit
Battery voltage below limit
If Battery voltage (Ubatt_U) > 17V or 31V for
mor ethan =0.5sec a warning is generated
Battery voltage above warning threshold
Battery voltage above warning threshold
(~38,9Volt), Short cut to battery possible.
Battery voltage below warning threshold,
Short cut to ground
Action
Check sensor and if necessary replace it, check
connection cable and if necessary
repair or replace it.
Check sensor and if necessary replace it, check
connection cable and if necessary
repair or replace it
Measure Voltage at Coolant Temperature
Sensor and renew harness if needed.
Check coolant level, inspect cooling system for
leakage and if necessary repair it,
check sensor and wiring
Check cabling, check rail pressure sensor and if
necessary replace it,
check connection cable and if necessary repair
or replace it.
Check cabling, check rail pressure sensor and if
necessary replace it,
check connection cable and if necessary repair
or replace it.
Threshold for error detection is an internal ECU
threshold.
Reset the fault and at reappearance check ECU
and injection system
Check alternator, regulator of alternator and if
necessary replace it, check wiring and
voltage of alternator
Check alternator, cabling, contact resistance,
safety fuses, too high load in energy
system, check battery and if necessary replace
it
Check wiring harness and connected
alternator.
Check wiring harness and connected
alternator.
Check wiring harness and connected
alternator.
3121671