JLG 400S Service And Maintenance Manual page 255

Deutz Blink
SPN FMI
Code Code
523935 12 168 763
523936 12 169 764
523938 9 133 766
523939 9 134 766
523940 9 135 766
523941 9 140 767
523942 9 141 767
523943 9 142 767
3121671
Table 3-16. Deutz Engine Fault Codes
Description
Timeout Error of CAN-Transmit-Frame
EEC3VOL1; Engine send messages
Timeout Error of CAN-Transmit-Frame
EEC3VOL2; Engine send messages
Timeout Error (BAM to packet) for CAN-
Receive-Frame AT1IGCVol1 information;
factors & Sensor calibration for NOX Sensor
(SCR-system upstream cat; DPF-system
downstream cat).
Broadcast Announce Message of the
calibra- tion message
of the upstream catalytic NOx sensor has
failed.
Timeout Error (BAM to BAM) for CAN-
Receive-Frame AT1IGCVol1 information.
factors & Sensor calibration for NOX Sensor
(SCR-system upstream cat, DPF-system
downstream cat).
Timeout Error (PCK2PCK) for CAN-Receive-
Frame AT1IGCVol1 information; factors &
Sensor calibration for NOX Sensor (SCR-sys-
tem upstream cat; DPF-system
downstream cat).
Timeout Error (BAM to packet) for CAN-
Receive-Frame AT1OGCVol2 information;
factors & Sensor calibration for NOX Sensor
(SCR-system downstream cat; DPF-system
downstream cat)
Timeout Error (BAM to BAM) for CAN-
Receive-Frame AT1OGCVol2 information,
Calibration message 1 of the after catalyst
NO sensor has failed.
Factors & Sensor calibration for NOX Sensor
(SCR-system downstream cat, DPF-system
downstream cat)
Timeout Error (PCK2PCK) for CAN-Receive-
Frame AT1OGCVol2 information; factors &
Sensor calibration for NOX Sensor (SCR-sys-
tem downstream cat; DPF-system
downstream cat)
SECTION 3 - CHASSIS & TURNTABLE
Possible Cause
Fault is detected if a TimeOut of the EEC3VOL1
frame has occured.
Timeout Error (Missing CAN Bus message)
Failure of the CAN Bus message
Defective Nox sensor, faulty parameterization NOX sensor and sensor connection check
Failure of the CAN Bus message
Timeout Error (Missing CAN Bus message)
Defective Nox sensor, faulty parameterization. NOX downstream sensor and sensor
The fault is detected when a timeout error in
packet 2 of NOxSenVol2Rx frame occurs.
Action
Check wiring harness and customer nodes
Check wiring harness and customer nodes
NOX sensor and sensor connection check
NOX sensor and sensor connection check
NOX downstream sensor and sensor
connection check
connection check.
NOX downstream sensor and sensor
connection check
3-197