Composite Bearing Installation - JLG 400S Service And Maintenance Manual

Hide thumbs Also See for 400S:

Table of Contents

SECTION 5 - BASIC HYDRAULICS INFORMATION & SCHEMATICS

NOTE: Install pin into the composite bearing dry. Lubrication is

not required with nickel plated pins and bearings.

Figure 5-72. Composite Bearing Installation

14. Inspect the oil ports for blockage or the presence of dirt

or other foreign material. Repair as necessary.

Inspect piston rings for cracks or other damage. Replace

if necessary.

NOTE: Prior to cylinder assembly, ensure that the proper cylinder

seal kit is used. See the respective JLG Parts Manual.

NOTE: Apply a light film of hydraulic oil to all components prior to

1. A special tool is used to install a new rod seal into the

applicable cylinder head groove.

Figure 5-73. Rod Seal Installation

WHEN INSTALLING NEW SEALS, ENSURE SEALS ARE INSTALLED PROPERLY.

IMPROPER SEAL INSTALLATION COULD RESULT IN CYLINDER LEAKAGE AND

IMPROPER CYLINDER OPERATION.

Figure 5-74. Cylinder Head Seal Installation

Troubleshooting