JLG 400S Service And Maintenance Manual page 81

SHARP EDGES IN COUNTERBORE CAN CUT AND CAUSE INJURY WHEN INSTALL-
ING O-RING.
16. Set cover (6A) on table, interior side up. Grease O-ring (5) and
place in counterbore around edge of cover (6A).
NOTE: O-ring may be stretched or pinched together to make it fit
counterbore.
17. Place cover sub-assembly (6) on ring gear (4). Align pipe
plug holes before disassembly.
18. Place four flat washers (16) on top of bolt holes in cover
sub-assembly.
3121671
SECTION 3 - CHASSIS & TURNTABLE
19. Place shoulder bolts (13) in four shoulder bolt holes in
cover (6) and hand-tighten.
20. Place remaining 12 flat washers (16) on remaining bolt
holes in cover (6).
21. Place 12 bolts in remaining bolt holes in cover (6) and
tighten.
3-23