SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
7.4 AMP CONNECTOR
Assembly
Check to be sure the wedge lock is in the open, or as-shipped,
position (See Figure 7-9.). Proceed as follows:
Figure 7-9. Connector Assembly Figure 1
7-8
1. To insert a contact, push it straight into the appropriate
circuit cavity as far as it will go (See Figure 7-11.).
2. Pull back on the contact wire with a force of 1 or 2 lbs. to
be sure the retention fingers are holding the contact
(See Figure 7-11.).
Figure 7-10. AMP Connector
3121671