Double Wrench Method - JLG 400S Service And Maintenance Manual

SECTION 5 - BASIC HYDRAULICS INFORMATION & SCHEMATICS

Double Wrench Method

To prevent undesired hose or connector rotation, two
wrenches must be used; one torque wrench and one backup
wrench. If two wrenches are not used, inadvertent component
rotation may occur which absorbs torque and causes
improper joint load and leads to leaks. For hose connections,
5-46
the 'layline' printed on the hose is a good indicator of proper
hose installation. A twisted lay-line usually indicates the hose
is twisted. See Figure 5-11. for double wrench method require-
ments.
Figure 5-11. Double Wrench Method
3121671