JLG 400S Service And Maintenance Manual page 219

Deutz Blink
SPN FMI
Code Code
102 4 777 223
105 0 996 233
105 0 997 233
105 1 992 128
105 3 994 128
105 4 995 128
107 0 752 136
110 0 98 232
110 0 99 232
110 1 93 225
3121671
Table 3-16. Deutz Engine Fault Codes
Description
Charge air pressure sensor: the measured
voltage of sensor by ECU is out of the target
range
Charge air temperature downstream
calculated by ECU is above the target
range.
The ECU activates a system reaction.
Charge air temperature downstream
calculated by ECU is under the shut down
thresh- old.
The ECU activates a system reaction.
Charged Air cooler down stream
temperature.
Temperature below lower physical thresh-
old.
Charge air temperature sensor: the voltage
of sensor measured by ECU is out of the tar-
get range.
Charge air temperature sensor: the voltage
of sensor measured by ECU is out of the tar-
get range.
Air filter differential pressure: the pressure
difference of the intake air between the
filter inlet and outlet calculated by ECU is
above the target range and the ECU
activates a system reaction
Coolant temperature: the coolant tempera-
ture calculated by ECU is above the target
range; the ECU activates a system reaction.
Coolant temperature: the coolant
temperature calculated by ECU is above the
target range.
The ECU activates a system reaction.
Coolant temperature sensor: the voltage of
the sensor measured by ECU is out of the
tar- get range.
SECTION 3 - CHASSIS & TURNTABLE
Possible Cause
The Sensor Voltage is below the Threshold.
Charge air temperature (downstream) over
warning threshold.
Charge air temperature (downstream) over
the low threshold.
Sensed temperature within intake air
manifold
< threshold.
Short circuit to battery. sensor voltage > limit The sensor raw signal Air_uRawTCACDs (volt-
Short circuit to ground or open load. sensor
voltage < limit.
Pressure loss above target range with system
reaction, air filter clogged or defective,
sensor not working, connection cable
damaged
Pressure value above warning threshold
Cooling temperature too high. Coolant
temper- ature above warning threshold.
Coolant temperature above shut off threshold. Clean radiator, check fan drive, check coolant
Suspected components: wiring harness, cool-
ant temperature sensor.
Action
Check cabling, if charge air pressure/
temperature sensor is not working, check
sensor and
if necessary replace it, check connection cable
and if necessary repair or replace it
Check CAC system and clean it. Check fan
functionality.
Check cooling performance with temperature
measurement.
Check CAC system and clean it. Check fan
functionality. Check cooling performance
with temperature measurement.
actual temperature below -40°C?
exchange sensor
age) > Air_SRCTCACDs.uMin_C.
Check CAC-sensor and if necessary replace it,
check connection cable and if
necessary repair or replace it.
The sensor raw signal Air_uRawTCACDs (volt-
age) is below Air_SRCTCACDs.uMin_C.
Check CAC-sensor and if necessary replace it,
check connection cable and if necessary repair
or replace it
Check air filter and if necessary clean or renew
it, check cabling, check sensor and if
necessary replace it, check connection cable
and if necessary repair or replace it
Clean radiator, check fan drive, check coolant
level, check cooling system in general,
check thermostat function, check water
pump.
level, check cooling system in general,
check thermostat function, check water
pump.
Check wiring harness and connected Coolant
Temp Sens.
3-161