Generator Disassembly And Assembly - JLG 400S Service And Maintenance Manual

Hide thumbs Also See for 400S:

Table of Contents

SECTION 3 - CHASSIS & TURNTABLE

Generator Disassembly and Assembly

Refer to Figure 3-70. and Figure 3-71. to determine if trouble is

in stator, rotor, control box, or combination of these compo-

2. Stator Assembly

DO NOT DAMAGE ROTOR OR STATOR WINDINGS DURING DISASSEMBLY AND

ASSEMBLY PROCEDURE.

1. Mark and disconnect all electrical leads, secure using

Figure 3-69. Generator Disassembly and Assembly

2. Remove brush holder assembly.

3. Disassemble generator parts shown in Figure 3-69.

4. Clean all parts with approved solvent and dry with com-

pressed air, If applicable.

5. Inspect all part for damage. Replace if necessary.

1. Assemble generator parts using torque values in table.

2. Reconnect all leads. Use cable ties to secure leads away

from moving or hot parts.