Mixer Assembly - JLG 400S Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE
INSTALLATION
LIGHTLY LUBRICATE BOTH THROTTLE CONTROL DEVICE TO ADAPTER O-RINGS.
1. Install the o-ring on throttle body. Press it down to the
bottom of the surface.
2. Install the two quad seals. Install one seal at a time to
insure the seal does not roll. The seal must sit flat on the
throttle body.
3-142
3. Attach mixer and throttle body together. The two parts
do not bolt together; they will be secured when you
mount it on the intake. Notice the orientation of the air
inlet and throttle body cover.
4. Place gasket on intake manifold and attach mixer/throt-
tle assembly to manifold.
Figure 3-117. Mixer Assembly
3121671