Maintenance And Lubrication - JLG 400S Service And Maintenance Manual

SECTION 1 - SPECIFICATIONS

1.7 MAINTENANCE AND LUBRICATION

NOTE: The following numbers correspond to those in Figure 1-1.,
Figure 1-2., Figure 1-3. and Figure 1-4.
Table 1-18. Lubrication Specifications
KEY
MPG Multipurpose Grease having a minimum dripping point of 350° F (177° C).
Excellent water resistance and adhesive qualities, and being of extreme
pressure type.
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classification GL-5 or
MIL-Spec MIL-L-2105
HO Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid 424.
EO Engine (crankcase). Gas (5W30)- API SN, -Arctic ACEA AI/BI, A5/B5 - API SM,
SL, SJ, EC, CF, CD - ILSAC GF-4. Diesel (15W40, 5W30 Arctic) - API CJ-4.
OGL Open Gear Lubricant - Mobiltac375 or equivalent.
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERATION UNDER NORMAL
CONDITIONS. FOR MACHINES USED IN MULTI-SHIFT OPERATIONS AND/OR
EXPOSED TO HOSTILE ENVIRONMENTS OR CONDITIONS, LUBRICATION FREQUEN-
CIES MUST BE INCREASED ACCORDINGLY.
NOTE: It is recommended as a good practice to replace all filters
at the same time.
1. Swing Bearing - Internal Ball Bearing
Lube Point(s) - 2 Grease Fittings
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hours of operation
Comments - Fittings in center of bearing: Remote
Access is optional: Apply grease and rotate in 90
degree intervals until bearing is completely lubri-
cated.
1-10
SPECIFICATIONS
2. Wheel Drive Hub
Lube Point(s) - Level/Fill Plug
Capacity - 24 oz. (0.8 L)(1/2 Full)
Lube - EPGL
Interval - Check level every 3 months or 150 hrs of
operation; change every 2 years or 1200 hours of
operation.
3. Drive Brake
Lube Point(s) - Fill Plug
Capacity - 27 oz. (0.8 L)
Lube - DTE-13M
Interval - Change as necessary.
OIL LEVEL CHECK
AND FILL
3121671