JLG 400S Service And Maintenance Manual page 462

SECTION 6 - JLG CONTROL SYSTEM
Table 6-2. Machine Configuration Programming Information (Software Version P2.10)
Configuration
Number
Label/Digit
SKYGUARD: 1
12
2
GEN SET/WELDER: 1
13
2
GEN SET CUTOUT: 1
14*
2
* Only visible if Gen Set / Welder Menu selection is not NO.
H & T LIGHTS: 1
15*
2
* Only visible under certain model selections.
LOAD SYSTEM: 1
16*
2
3
4
5
* Only visible under certain market selections.
* Certain market selections will limit load system options or alter default setting.
FUNCTION CUTOUT: 1
17*
2
3
4
* Only visible under certain market selections.
* Certain market selections will limit function cutout options or alter default setting.
6-22
NO: No SkyGuard system installed.
YES: SkyGuard system installed.
NO: No generator installed.
BELT DRIVE: Belt driven setup.
MOTION ENABLED: Motion enabled when generator is ON.
MOTION CUTOUT: Motion cutout in platform mode only.
NO: No head and tail lights installed.
YES: Head and tail lights installed.
NO: No load sensor installed.
WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5 sec ON, 2 sec OFF).
CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform alarm beeps (5 sec ON, 2 sec
OFF).
SPECIAL 1: Functions in creep, overload lamp lit, disables telescope out & lift up, platform alarm beeps (5 sec ON, 2 sec
OFF).
NO: No drive cutout.
BOOM CUTOUT: Boom function cutout while driving above elevation.
DRIVE CUTOUT: Drive & steer cutout above elevation.
DRIVE CUT E&T: Drive & steer cutout above elevation and tilted.
Description
Default
Number
2
1
1
1
1
1
3121671