JLG 400S Service And Maintenance Manual page 224

SECTION 3 - CHASSIS & TURNTABLE
Deutz Blink
SPN FMI
Code Code
630 12 377 281
630 12 378 281
639 14 84 271
651 3 580 154
651 5 568 154
652 3 581 155
652 5 569 155
653 3 582 156
3-166
Table 3-16. Deutz Engine Fault Codes
Description
Internal hardware monitoring: the ECU
finds an error during the access to its
EEPROM memory or works with an
alternative value
Internal hardware monitoring: the ECU
finds an error during the access to it's
EEPROM memory or works with an
alternative value
CAN bus 0: the ECU is not allowed to send
messages, because the status "BusOff " is
detected.
Injector cyl. 1: the current drop measured
by
ECU is above the target range
Injector cyl. 1: interruption of electrical
connection
Injector cyl. 2: the current drop measured
by
ECU is above the target range
Injector cyl. 2: interruption of electrical
connection
Injector cyl. 3: the current drop measured
by
ECU is above the target range
Possible Cause
Minimum 3 blocks could not be read, EEPROM
has Checksum Error
Block could not be written for minimum 3
times
CAN BusOff error; CAN 0 (Customer CAN)
Suspected Components:
injector cylinder 1
wiring harness, cable break or short circuit,
sen- sor defective, connection cable
damaged
Interruption of electronic connection Injector
cyl. 1
Suspected Components:
injector cylinder 2
wiring harness, cable break or short circuit,
sen- sor defective, connection cable
damaged
Interruption of electronic connection Injector
cyl. 2
Suspected Components:
injector cylinder 3
wiring harness, cable break or short circuit,
sen- sor defective, connection cable
damaged
Action
There is no healing possible for the error. In
the every new initialization phase, the
debounce level is set to zero.
If not programmed, EEPROM is defect -->ECU
is defect, reprogram ECU and if
necessary replace it
Threshold for error detection is an internal ECU
threshold.
If not programmed, EEPROM is defect --> ECU
is defect, reprogram ECU and if
necessary replace it.
Threshold for error detection is an internal ECU
threshold.
BusOff bit for CAN A node is set.
Check wiring of CAN bus and if necessary
repair it, check connection cable and if
necessary repair or replace it, check resistance
in
CAN lines (120 Ohm).
Threshold for error detection is an internal ECU
threshold.
Check wiring harness, injectors and if
necessary repair/replace it. Use SerDia Injector
test for diagnosis.
Threshold for error detection is an internal ECU
threshold.
Check wiring harness, injectors and if
necessary repair/replace it.
Threshold for error detection is an internal ECU
threshold.
Check wiring harness, injectors and if
necessary repair/replace it. Use SerDia Injector
test for diagnosis.
Threshold for error detection is an internal ECU
threshold.
Check wiring harness, injectors and if
necessary repair/replace it.
Threshold for error detection is an internal ECU
threshold.
Check wiring harness, injectors and if
necessary repair/replace it. Use SerDia Injector
test for diagnosis.
3121671