Replacing Engine Oil - JLG 400S Service And Maintenance Manual

SECTION 3 - CHASSIS & TURNTABLE
5. Insert the dipstick to the stop and remove again. Check
the oil level, and if necessary, top the oil level up to the
MAX mark with an approved grade and type of oil as
outlined in the engine manufacturer's operator's man-
ual. Refer to Figure 3-89., Deutz Engine Dipstick.
0,1,080 2,/
/(9(/
0$;,080 2,/
/(9(/
0,1,080 /(9(/
2,/ +27
0,1,080 /(9(/
2,/ &2/'
0$;,080 /(9(/
2,/ &2/'
127( +RW RLO FKHFNV VKRXOG QRW EH PDGH XQWLO WKH HQJLQH
KDV EHHQ VKXW GRZQ IRU D SHULRG RI  PLQXWHV
Figure 3-89. Deutz Engine Dipstick
6. Replace the dipstick making sure that it is fully seated in
the dipstick tube to seal off the crankcase.
3-116
0$;,080 /(9(/
2,/ +27

Replacing Engine Oil

1. Allow the engine to warm up. The engine oil should
reach approximately 176° F (80° C).
2. Make sure the machine and engine are level.
3. Switch off the engine.
4. Place an oil tray under the engine.
HOT ENGINE OIL CAN CAUSE BURNS, AVOID CONTACT WITH HOT OIL WHEN
DRAINING.
COLLECT USED OIL IN A CONTAINER SUITABLE FOR DISPOSAL OR RECYCLING.
DISPOSE OF USED ENGINE OIL IN ACCORDANCE WITH ENVIRONMENTAL REGU-
LATIONS.
5. Open the oil drain valve.
6. Drain the oil.
7. Close the oil drain valve.
3121671