Inspect The Service Brake; Disc Brake Pads - Taylor-Dunn ET-3000 Manual

Brakes

INSPECT THE SERVICE BRAKE

Disc Brake Pads

Note: The brake pad must be removed to accurately measure the lining
Measure the brake pad lining at the thinnest point on the pad. If the brake pad lining is 1/16-inch or less
then the brake pad must be replaced.
It is recommended to replace the left and right side brake pads as a set.
Page 2
Current Taylor-Dunn
possibility that the original brakes were replaced with aftermarket
parts containing asbestos. Since this possibility exists, all brake parts
should be handled as if they contain asbestos. Refer to Appendix C
for recommended handling precautions.
thickness. Refer to Replace the Front or Rear Brake Pads section
for information on removing the brake pads.
brakes are asbestos free. However, there is the
®
T-48 AC / ET 3000
MB-T48-02