Transaxle-Gt; Transaxle Assembly; Remove; Install - Taylor-Dunn TT-316-36 Service And Replacement Parts Manual

TT-316-36

TRANSAXLE ASSEMBLY

WARNING
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.

Remove

1: Raise the rear of the vehicle and support with jack stands.
2: Remove the wheels. Refer to procedure in "Tires and Wheels" section.
3: Disconnect the wiring from the motor.
4: Disconnect the hydraulic brake lines from the left and right brake bodies.
5: Remove the nuts from all six leaf spring to frame mounting bolts.
6: Place a trolly under the axle assembly and lower the vehicle enough to remove pressure from the spring
mounting bolts so that they can be removed.
7: Raise the frame and remove the transaxle assembly from under the vehicle.
8: Lower the frame to the ground or leave supported on jack stands.

Install

1: Reinstall in reverse order of removal.
a. Tighten the motor wire terminals per torque listed in the Hardware Torque table at the end of this section.
b. Bleed the brake system
2: Reconnect the battery, remove the blocks from behind the wheels and test drive the vehicle.
MT-316-06
Drive Axle-GT
Always use a lifting strap, hoist, and jack stands, of
adequate capacity to lift and support the vehicle.
Failure to use lifting and support devices of rated load
capacity may result in severe bodily injury.
Page 33