Connector 'J6 | Com1' (Remote Communications And Discrete Control Port); Table 2-8. 'J6 | Com1' Pin Assignments - Comtech EF Data LPOD Series Installation And Operation Manual

2.3.5 Connector 'J6 | COM1' (Remote Communications and Discrete Control
Port)
PS 1/PS 1.5
The 'J6 | COM 1' discrete control connector is the primary input for controlling and monitoring the
LPOD. It is a 19-pin circular connector, type MS3112E14-19S.
Mating connector:
MS3116J14-19P or ITT KPT06J14-19P
Pin
A RS485_+RX
B RS485_-RX
C RS485_+TX
D RS485_-TX
E RS232_RD
F Ethernet TX+
G RS232_TD
H Ethernet TX-
J TX/RX Switch Drive 1 Pos
K GND
L SUMFLT In
M SUMFLT Out
N TX Switch Pos 1 Ind
P RX Switch Pos 1 Ind
R +24V
S System Mute Control
T Switch Common
U Ethernet RX-
V Ethernet RX+
System Connectors, Installation, and Startup
Low Power Outdoor (LPOD) Amplifier/Block Up Converter (BUC)
PS 2

Table 2-8. 'J6 | COM1' Pin Assignments

Name
Pin 3 of DB9 female connector
Pin 3 of RJ45 female connector
Pin 2 of DB9 female connector
Pin 6 of RJ45 female connector
Not for customer use
Ground (also Pin 5 of DB-9F connector)
Open when faulted, otherwise+5 VDC
When faulted, tied to Pin K, otherwise open
Online/Offline indication
Not for customer use
Not for customer use
When AUX=1, unit is muted until this pin is tied to ground (Pin K). When
tied to ground, the unit unmutes. See the AUX remote command in
Chapter 5. SERIAL INTERFACE OPERATION.
GND reference for Pin N
Pin 2 of RJ45 female connector
Pin 1 of RJ45 female connector
2–11
Revision 15
Description
MN-LPOD