Mitsubishi Electric MELSEC iQ-R-R00CPU User Manual page 371

Setting method for the local devices
Set the range where each device will be used as a local device and also set whether or not it should be used.
■Range setting
The range setting for local devices is common to all the programs. Therefore the range for local devices cannot be set for
each program.
Operating procedure
"Device/Label Memory Area Detailed Setting" window
"Device Setting" window
Configure the setting range of the local device within the range which has been set for the number of device
points. The number of local devices used is calculated by the following calculation formula. Set the number of
local devices used so that the number is equal to or less than the capacity of the local device area.
Total number of local devices used = ((A  16) + B + (C  2) + (D  4) + ((E  2)  16))  F
• A: Number of points of the local devices M and V
• B: Number of points of the local devices D, T (current value), ST (current value), and C (current value)
• C: Number of points of the local device LC (current value)
• D: Number of points of the local devices LT and LST
• E: Number of points of the local devices T (contact/coil), ST (contact/coil), C (contact/coil), and LC (contact/
coil)
• F: Number of programs using the local device
■Setting unit
The increment of setting of a local device is the same as that of a global device. ( Page 332 Range of use of device
points)
1.
Click "Detailed Setting" on the "Device Setting"
window.
[CPU Parameter]  [Memory/Device Setting]
 [Device/Label Memory Area Detailed
Setting]  [Device Setting]  [Detail Setting]
2.
Set the range where each device will be used
as a local device.
21
21 DEVICES
369
21.19 Local Device