Before Exposure; During Exposure - FujiFilm FDR ES DR-ID1270 Operation Manual

1.3.2 Before Exposure

The use of an air-conditioner may dramatically changes the temperature of the room where the
system is installed. This may cause dew condensation on the system, resulting in quality problems.
When an air-conditioner is used, change the temperature gradually to avoid temperature variation
in order not to cause dew condensation.
If an exposure is made with the front and rear of the flat panel
1
sensor facing the other way round, not only the re-exposure
is required but electric parts of inside the equipment may be
damaged.

1.3.3 During Exposure

Before making an exposure, make sure that exposure conditions most appropriate for this system
are set.
Do not apply an excessive force to the exposure plane.
The sensor inside the flat panel sensor may be damaged,
and it may not be possible to make an exposure properly.
<Load restriction>
Entire surface load : DR-ID1271SE, DR-ID1272SE, DR-ID1273SE,
Local load : DR-ID1271SE, DR-ID1272SE, DR-ID1273SE,
Use the flat panel sensor on a flat floor or platform.
When an excessive force is applied to the unit when it is tilted, the
sensor inside the flat panel sensor may be damaged.
Do not place a metal plate, etc., which blocks radio waves, before
the antenna. Otherwise, data may not be sent correctly from the flat
panel sensor.
1-18
DR-ID1270 Operation Manual
DR-ID1274SE and DR-ID1275SE :
300kg (661.5 lb)
DR-ID1274SE and DR-ID1275SE :
120kg (264.6 lb) / ø40mm (1.6 in.)
(Based on FUJIFILM measurement specifications)
897N120821E
Exposure plane of the
flat panel sensor
Antenna
Antenna