Reset The Switch; Reboot The Switch; Reload The Configuration File - ZyXEL Communications XS3800-28 User Manual
28-port 10gbe l3 managed switch
Hide thumbs
Also See for XS3800-28:
- User manual (719 pages) ,
- Cli reference manual (407 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Misconfigure the text configuration file.
5
Forget the password and/or IP address.
6
Prevent all services from accessing the Switch.
7
Change a service port number but forget it.
8
You forgot to log out of the Switch from a computer before logging in again on another computer.
9
Note: Be careful not to lock yourself and others out of the Switch. If you do lock yourself out,
try using out-of-band management (through the management port) to configure the
Switch.
4.8 Reset the Switch
If you lock yourself (and others) from the Switch or forget the administrator password, you will need to
reload the factory-default configuration file or reset the Switch back to the factory defaults.
See
Section 3.1 on page 45
4.8.1 Reboot the Switch
Press the RESET button to reboot the Switch without turning the power off. See
more information about the LED behavior.
4.8.2 Reload the Configuration File
Uploading the factory-default configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all previous configurations and the speed of the
console port will be reset to the default of 115200 bps with 8 data bit, no parity, one stop bit and flow
control set to none. The password will also be reset to "1234" and the IP address to 192.168.1.1 or DHCP-
assigned IP.
To upload the configuration file, do the following:
Connect to the console port using a computer with terminal emulation software.
1
Disconnect and reconnect the Switch's power to begin a session. When you reconnect the Switch's
2
power, you will see the initial screen.
When you see the message "Press any key to enter Debug Mode within 3 seconds ..." press
3
any key to enter debug mode.
Enter atlc after the "Enter Debug Mode" message.
4
Wait for the "Starting XMODEM upload" message before activating XMODEM upload on your
5
terminal.
After a configuration file upload, type atgo to restart the Switch.
6
Chapter 4 Web Configurator
to see how to use the RESTORE button to restore the factory default file.
XS3800-28 User's Guide
86
Section 3.3 on page 52
for
Advertisement
Table of Contents
Troubleshooting
