Remote Diagnostics; Setting Remote Access - Siemens SINUMERIK 840D sl Operating Manual

Alarm, error, and system messages

13.9 Remote diagnostics

Copy file
13.9 Remote diagnostics
13.9.1

Setting remote access

You can influence the remote access to your control in the "Remote diagnostics (RCS)"
window.
Here, rights for all types of remote control are set. The selected rights are defined from the
PLC and using the setting at the HMI.
The HMI can restrict the rights specified from the PLC, but however, cannot extend the rights
beyond the PLC rights.
If the settings made permit access from outside, then this is still dependent on a manual or
automatic confirmation.
Rights for remote access
The "Specified from PLC" field shows the access rights for remote access or remote
monitoring specified from the PLC.
In the "Selected in the HMI" selection box, you have the possibility of setting rights for
remote control:
● Do not permit remote access
● Permit remote monitoring
● Permit remote control
644
1. Select the "Start-up" operating area.
2. Press the "System data" softkey and open the specified folder.
As you cannot open screenshots in SINUMERIK Operate, you must
copy the files to a Windows PC either via "WinSCP" or via a USB-
FlashDrive.
You can open the files using a graphics program, e.g. "Office Picture
Manager".
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling