Siemens SINUMERIK 840D sl Operating Manual page 288

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Creating a ShopMill program

7.17 Example, standard machining

• When selecting the milling tool, please make sure that the tool diameter is large enough

• If you want to finish cut the pocket, you must assign parameters UXY and UZ accordingly

5. Milling a rectangular pocket (large)

Press the "Accept" softkey.

to cut the intended pocket. A message will be displayed if you make a mistake.

and add a second solid machining cycle for finishing.

Press the "Milling", "Pocket" and "Rectangular pocket" softkeys.

The "Rectangular Pocket" input window opens.

Enter the following technology parameters:

T End mill_10mm

Enter the following parameters:

Reference point

Machining position

Select, e.g. to the retraction plane

F 0.04 mm/tooth V 260 m/min

Roughing (∇)

Single position

Operating Manual, 03/2013, 6FC5398-7CP40-3BA1

Sinumerik 828d