Siemens SINUMERIK 840D sl Operating Manual page 381

● Numbers
● Text
Mirror writing
You can engrave the text mirrored on the workpiece.
Full circle
If you want to distribute the characters evenly around a full circle, enter the arc angle
α2=360°. The cycle then distributes the characters evenly around the full circle.
Parameters, G code program
PL Machining plane
RP Retraction plane
SC Safety clearance
F Feedrate
Parameter Description
FZ Depth infeed rate
(only for G code)
FZ Depth infeed rate
(only for ShopMill)
Alignment
•
•
•
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
When outputting number (e. g. measurement results), you can select the output format
(digits either side of the point) of the number to be engraved.
Instead of entering a fixed text in the engraving text field, you can specify the text to be
engraved via a text variable (e. g., _VAR_TEXT="ABC123").
mm
mm
*
(linear alignment)
(curved alignment)
(curved alignment)
Programming technological functions (cycles)
Parameters, ShopMill program
T Tool name
D Cutting edge number
F Feedrate
S / V Spindle speed or constant
cutting rate
8.2 Milling
mm/min
mm/tooth
rpm
m/min
Unit
*
mm/min
mm/tooth
381