Repeating Positions - Siemens SINUMERIK 840D sl Operating Manual

Programming technological functions (cycles)
8.1 Drilling
Display or hide all positions at once
8.1.14

Repeating positions

Function
If you want to approach positions that you have already programmed again, you can do this
quickly with the function "Repeat position".
You must specify the number of the position pattern. The cycle automatically assigns this
number (for ShopMill). You will find this position pattern number in the work plan (program
view) or G-code program after the block number.
332
4. Press the "Hide position" softkey.
The "Hide position" window opens on top of the input form of the
position pattern. The positions are displayed in a table.
The numbers of the positions, their angle(α) as well as a checkbox with
the state (activated = check mark set / deactivated = no check mark set)
are displayed.
The selected position in the graphic is highlighted in color.
5. Using the mouse, select the required position and deactivate or activate
the checkbox in order to hide the position or display it again.
In the diagram, skipped positions are shown in the form of a circle and
displayed (active) positions are shown in the form of a cross.
Note: You have the option of selecting individual positions using the
<Cursor up> or <Cursor down> keys – and hiding and displaying using
the <SELECT> key.
1. Press the "Hide all" softkey to hide all positions.
2. Press the "Show all" softkey to display all positions again.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling