Machining the workpiece
4.10 Editing a program
Note
Pasting program blocks
JobShop machining steps cannot be copied into a G code program.
Requirement
You have opened a program in the editor.
Procedure
See also
Copying/pasting/deleting a program block (Page 176)
180
1.
Press the ">>" and "Open additional program" softkeys.
The "Select Additional Program" window is opened.
2.
Select the program or programs that you wish to display in addition to
the already opened program.
3.
Press the "OK" softkey.
The editor opens and displays both programs next to each another.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling