Plunge Turning Residual Material (Cycle952) - Siemens SINUMERIK 840D sl Operating Manual

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

Programming technological functions (cycles)

8.5 Contour turning- only for G code programs

Compensation allowance in X and Z direction (inc) – (only for allowance)

Set machining area

Set machining area limits

with limited machining area only, yes:

1. Limit XA ∅

2. Limit XB ∅ (abs) or 2nd limit referred to XA (inc)

2. Limit ZB (abs) or 2nd limit referred to ZA (inc)

Number of grooves

Distance between grooves

* Unit of feedrate as programmed before the cycle call

Plunge turning residual material (CYCLE952)

The "Plunge turning residual material" function is used when you want to machine the

material that remained after plunge turning.

For a G code program, select the function in the screen. Material that remains as part of the

finishing allowance is not residual material. The "Plunge turning residual material" function

allows you to remove unwanted material with a suitable tool.

The "Plunge turning residual material" function is a software option.

Positive value: Compensation allowance is kept

Negative value: Compensation allowance is removed in addition to finishing

The part program to be executed has been created and you are in the

Press the "Turning" and "Contour turning" softkeys.

Press the "Plunge turning residual material" softkey.

The "Plunge turning residual material" input window opens.

Operating Manual, 03/2013, 6FC5398-7CP40-3BA1

Sinumerik 828d