Setting-Up Events - Siemens SINUMERIK 840D sl Operating Manual

18.4

Setting-up events

In the "Send SMS for the following events" area, select the events using the check box,
which when they occur, an SMS is sent to the user.
● Programmed messages from the part program (MSG)
● Select the following events using the <SELECT> key
● Messages/alarms from the Tool Manager
● Measuring cycle messages for tools
● Measuring cycle messages for workpieces
● Sinumerik messages/alarms (error when executing)
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
- OR -
Press the "Default" softkey to accept the default values.
In the part program, program an MSG command via which you receive an SMS.
Example: MSG ("SMS: An SMS from a part program")
– The workpiece counter reaches the following value
An SMS is sent if the workpiece counter reaches the set value.
– The following program progress is reached (percent)
An SMS is sent if, when executing a part program, the set progress is reached.
– Actual NC program reaches runtime (minutes)
An SMS is sent after the set runtime has been reached when executing an NC
program.
– Tool usage time reaches the following value (minutes)
An SMS is sent if the usage time of the tool reaches the set time when executing a
part program (derived from $AC_CUTTING_TIME).
An SMS is sent if messages or alarms are output to the Tool Manager.
An SMS is sent if measuring cycle messages are output that involve tools.
An SMS is sent if measuring cycle messages are output that involve workpieces.
An SMS is sent if NCK alarms or messages are output that cause the machine to come to
a standstill.
Easy Message (828D only)
18.4 Setting-up events
697