8.2.12
Engraving (CYCLE60)
Function
The "Engraving" function is used to engrave a text on a workpiece along a line or arc.
You can enter the text directly in the text field as "fixed text" or assign it via a variable as
"variable text".
Engraving uses a proportional font, i.e., the individual characters are of different widths.
Approach/retraction
1. The tool approaches the starting point at rapid traverse at the height of the retraction
2. The tool moves to the machining depth FZ at the infeed feedrate Z1 and mills the
3. The tool retracts to the safety clearance at rapid traverse and moves along a straight line
4. Steps 2 and 3 are repeated until the entire text has been milled.
5. The tool moves to the retraction plane in rapid traverse.
Procedure
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
plane and adjusts to the safety clearance.
characters.
to the next character.
1.
The part program or ShopMill program to be processed has been
created and you are in the editor.
2.
Press the "Milling" softkey.
3.
Press the "Engraving" softkey.
The "Engraving" input window opens.
Programming technological functions (cycles)
8.2 Milling
377