Siemens SINUMERIK 840D sl Operating Manual page 539

...
The tool creation sequence can be defined differently.
Multiple load points
If you have configured several loading points for a magazine, then the "Select loading point"
window appears when a tool is created directly in an empty magazine location or when the
"Load" softkey is pressed.
Select the required load point and confirm with the "OK" softkey.
Additional data
If configured accordingly, the "New tool" window opens after the required tool has been
selected and confirmed with "OK".
You can define the following data in this window:
● Names
● Tool location type
● Size of tool
References:
For a description of configuration options, refer to the
Commissioning Manual SINUMERIK Operate / SINUMERIK 840D sl
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
If you want to create a tool that is not in the "Favorites" list, press the
softkey "Cutters 100-199", "Drill 200-299", or "Spec.tool 700-900".
The "New tool - milling cutter", "New tool - drill", or "New tool - special
tools" window opens.
4. Select the tool by placing the cursor on the corresponding icon.
5. Press the "OK" softkey.
The tool is added to the tool list with a predefined name. If the cursor
is located on an empty magazine location in the tool list, then the tool
is loaded to this magazine location.
Tool management
11.5 Tool list
539