Polar Coordinates - Siemens SINUMERIK 840D sl Operating Manual

Parameter
I
J
P
Z
F
8.7.12

Polar coordinates

If a workpiece has been dimensioned from a central point (pole) with radius and angles, you
will find it helpful to program these as polar coordinates.
You can program straight lines and circles as polar coordinates.
Defining a pole
You must define the pole before you can program a straight line or circle in polar
coordinates. This pole acts as the reference point of the polar coordinate system.
The angle for the first line or circle then needs to be programmed in absolute coordinates.
You can program the angles for any additional straight lines and circles as either absolute or
incremental coordinates.
Procedure
Parameter
X
Y
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Description
Center point of the helix in the X direction (abs or inc)
Center point of the helix in the Y direction (abs or inc)
Helix pitch The pitch is programmed in mm per revolution.
Target position of the helical end point (abs or inc)
Machining feedrate
1. The ShopMill program to be edited has been created and you are in the
editor.
2. Press the menu forward key and the "Polar" softkey.
3. Press the "Pole" softkey.
Description
Pole X (abs) or pole X referred to the last programmed position (inc)
Pole Y (abs) or pole Y referred to the last programmed position (inc)
Programming technological functions (cycles)
8.7 Additional cycles and functions in ShopMill
Unit
mm
mm
mm/rev
mm
mm/rev
mm/min
mm/tooth
Unit
mm
mm
507