Siemens SINUMERIK 840D sl Operating Manual page 175

Note
Replacing texts
• Read-only lines (;*RO*)
• Contour lines (;*GP*)
• Hidden lines (;*HD*)
See also
Editor settings (Page 181)
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
5. Press the "OK" softkey to start the search.
If the text you are searching for is found, the corresponding line is
highlighted.
6. Press the "Replace" softkey to replace the text.
- OR -
Press the "Replace all" softkey to replace all text in the file that
corresponds to the search term.
- OR -
Press the "Continue search" softkey if the text located during the search
should not be replaced.
- OR -
Press the "Cancel" softkey when you want to cancel the search.
If hits are found, the texts are not replaced.
If hits are found, the texts are replaced as long as the lines are not read-only.
If hidden lines are displayed in the editor and hits are found, the texts are replaced as
long as the lines are not read-only. Hidden lines that are not displayed, are not replaced.
Machining the workpiece
4.10 Editing a program
175