Machining the workpiece
4.10 Editing a program
Setting
Width of the program
with focus
Cut only after
selecting
Note
All entries that you make here are effective immediately.
Procedure
See also
Replacing program text (Page 174)
182
Meaning
Here, you enter the width of the program that has the input focus in the editor
as a percentage of the window width.
Yes: The cutting of program sections is possible only when program lines
•
have been selected, i.e. the "Cut" softkey only then is active.
No: The "Cut" softkey is available by default.
•
1.
Select the "Program" operating area.
You have activated the editor.
2.
Press the ">>" and "Settings" softkeys.
The "Settings" window opens.
3.
Make the desired changes here and press the "OK" softkey to confirm
your settings.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling