Continuing Program From Search Target - Siemens SINUMERIK 840D sl Operating Manual

Machining the workpiece
4.7 Starting machining at a specific point
Preconditions
1. You have selected the desired program.
2. The controller is in the reset state.
3. The desired search mode is selected.
Toggling between search pointer and search positions
See also
Selecting a program (Page 151)
4.7.2

Continuing program from search target

To continue the program at the desired position, press the <CYCLE START> key twice.
● The first CYCLE START outputs the auxiliary functions collected during the search. The
● Before the second CYCLE START, you can use the "Overstore" function to create states
160
NOTICE
Risk of collision
Pay attention to a collision-free start position and appropriate active tools and other
technological values.
If necessary, manually approach a collision-free start position. Select the target block
considering the selected block search type.
Press the "Search pointer" softkey again to exit the "Search Pointer"
window and return to the "Program" window to define search positions.
- OR -
Press the "Back" softkey.
You have now exited the block search function.
program is then in the Stop state.
that are required, but not yet available, for the further program execution.
By changing to the JOG REPOS mode, you can also manually traverse the tool from the
current position to the setpoint position, if the setpoint position is not to be automatically
approached after the program start
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling