Machining the workpiece
4.7 Starting machining at a specific point
Procedure
4.7
Starting machining at a specific point
4.7.1
Use block search
If you would only like to perform a certain section of a program on the machine, then you
need not start the program from the beginning. You can also start the program from a
specified program block.
Applications
● Stopping or interrupting program execution
● Specify a target position, e.g. during remachining
158
1.
Press the <REPOS> key.
2.
Select the axes to be traversed one after the other.
3.
Press the <+> or <-> key for the relevant direction.
The axes are moved to the interrupt position.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling