Siemens SINUMERIK 840D sl Operating Manual page 549

Column heading
Type
Tool name
ST
D
Δ Length
Δ Radius
T C
Tool life
Workpiece count
Wear *
*Parameter depends on
selection in TC
Setpoint
Prewarning limit
G
Further parameters
If you have created unique cutting edge numbers, they will be displayed in the first column.
Column heading
D no.
SN
SC
Milling
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Meaning
Tool type
Depending on the tool type (represented by an icon), certain tool offset
data is enabled.
The tool is identified by the name and the replacement tool number. You
can enter the name as text or number.
Note: The maximum length of tool names is 31 ASCII characters. The
number of characters is reduced for Asian characters or Unicode
characters. The following special characters are not permitted: | # ".
Replacement tool number (for replacement tool strategy).
Cutting edge number
Length wear
Radius wear
Selection of tool monitoring
- by tool life (T)
- by count (C)
- by wear (W)
The wear monitoring is configured via a machine data item.
Please refer to the machine manufacturer's instructions.
Tool life
Number of workpieces
Tool wear
Setpoint for tool life, workpiece count, or wear
Specification of the tool life, workpiece count or wear at which a warning
is displayed.
The tool is disabled when the checkbox is selected.
Meaning
Unique cutting edge number
Cutting edge number
Setting-up offsets
Display of the available setup offsets
Tool management
11.6 Tool wear
549