Machining the workpiece
4.10 Editing a program
4.10.5
Creating a program block
In order to structure programs to achieve a higher degree of transparency, you have the
option of combining several blocks (G-code and/or ShopMill machining steps) to form
program blocks.
You then have the option of opening and closing these blocks depending on your
requirement.
Display
Text
Spindle
Addit. run-in code
Automat. retraction
Structuring programs
● Before generating the actual program, generate a program frame using empty blocks.
● By forming blocks, structure existing G code or ShopMill programs.
Procedure
178
Meaning
Block designation
S1
•
S2
•
Spindle assignment. Defines at which spindle a program block is to be
executed.
Yes
•
If the block is not executed because the specified spindle should not be
processed, it is possible to temporarily activate a so-called "Addit. run-in
code".
No
•
Yes
•
Block start and block end are moved to the tool change point, i.e. the tool
is brought into a safe range.
No
•
1.
Select the "Program manager" operating area.
2.
Select the storage location and create a program or open a program.
The program editor opens.
3.
Select the required program blocks that you wish to combine to form a
block.
Operating Manual, 03/2013, 6FC5398-7CP40-3BA1
Milling